I have obtained a small bench mounted, Power brand surface grinder.
It's in good overall condition, but missing some minor parts.
I would like to request if any one has one of these, if they would be willing to take some photos of it?
Namely, the wheel guard (mine is missing), and the left handed nut that secures the wheel assembly.
Also, as I can't find any information for it:
- Recommended wheel diameter?
- Does the wheel mounting flange assembly come off the spindle? Mine is firmly attached, with no obvious was to apply a puller to it.
Any info keenly sought.
Unfortunately I don't see any model designation on it.
Jordan
Read the full thread at metalworkforums.com...
It's in good overall condition, but missing some minor parts.
I would like to request if any one has one of these, if they would be willing to take some photos of it?
Namely, the wheel guard (mine is missing), and the left handed nut that secures the wheel assembly.
Also, as I can't find any information for it:
- Recommended wheel diameter?
- Does the wheel mounting flange assembly come off the spindle? Mine is firmly attached, with no obvious was to apply a puller to it.
Any info keenly sought.
Unfortunately I don't see any model designation on it.
Jordan
Read the full thread at metalworkforums.com...
POWER surface grinder - info requested
0 commentaires:
Enregistrer un commentaire