Hey all,
I've got myself on old lathe ( ex School, very solid ), which was 3 phase.
I'm wanting to source an equivalent single phase motor.
The old one was a 415V - 1HP motor which ran @ 1425 RPM.
I've removed the old pulley ( a 5 1/2 inch 4 step pulley ), and ideally was wanting to find a motor that would run on single phase, and at least 1 HP ( prefer 2 HP ).
Has anyone had experience in doing this? Any advice on where in Melbourne or Australia to source a motor? I have all the measurements for the shaft etc which is 19mm.
Cheers
Seb
I've got myself on old lathe ( ex School, very solid ), which was 3 phase.
I'm wanting to source an equivalent single phase motor.
The old one was a 415V - 1HP motor which ran @ 1425 RPM.
I've removed the old pulley ( a 5 1/2 inch 4 step pulley ), and ideally was wanting to find a motor that would run on single phase, and at least 1 HP ( prefer 2 HP ).
Has anyone had experience in doing this? Any advice on where in Melbourne or Australia to source a motor? I have all the measurements for the shaft etc which is 19mm.
Cheers
Seb
fitting single phase motor to old 3 phase lathe
0 commentaires:
Enregistrer un commentaire