So this old linisher goes well most of the time, but cuts out (or rather throws the safety switch at the power board) when the motor gets too warm - I wouldn't call it hot. After about 15 minutes work. Even I can work for longer than that in one stretch. Is that just age, or faulty wiring (?), or can i repair/replace something to give me a bit more working time? Any advice much appreciated.
EDIT: Mmm, motors cooled down now but still throwing switch. So electrics is the issue...?
DSCN0451.jpgDSCN0452.jpg
EDIT: Mmm, motors cooled down now but still throwing switch. So electrics is the issue...?
DSCN0451.jpgDSCN0452.jpg
Linisher overheating
0 commentaires:
Enregistrer un commentaire