Hey guys, quick question from a noob school student. As the picture below shows, I built this desk horizontal desk hutch contraption thingooo. Anyway, before putting it together the bottom component bowed quite a bit. Then I put it together and due to some incorrect measurements the bottom has now got a cup in it around 5mm maximum in the centre, before tapering off on each end and sitting flat on each end. So, my question is. Is it possible and safe for me to run the entire project with the bottom face down over the jointer. Id be taking it very slowly in very small increments. Is it possible and safe? The sides are connected using lock mitre joints, where it mets the side panels. Thoughts? Or should I just line the bottom with black felt. Which i had a look at on the bottom and it to an extent hides it a bit.
IMG_1150.jpgIMG_1153.jpgIMG_1154.jpg
IMG_1150.jpgIMG_1153.jpgIMG_1154.jpg
0 commentaires:
Enregistrer un commentaire