hello, new to this forum here, i was recomended to post here by a friend to see if i could find someone to help me. i have two small pulleys that need moddifying but i dont have access to a lathe or mill.
the ID is currently .125" but i need it bored to .158"
if there is anyone close buy that could help me out or point me in the right direction would be greatly appreciated, cheers
would be more than welcome to throw a bit of cash or some beers if anyone can do it for me :)
the ID is currently .125" but i need it bored to .158"
if there is anyone close buy that could help me out or point me in the right direction would be greatly appreciated, cheers
would be more than welcome to throw a bit of cash or some beers if anyone can do it for me :)
0 commentaires:
Enregistrer un commentaire