HI.
I bought a GMC table saw new at auction to dedicate to one process.
However i need to build a cross cut sled to do up to two dozen short cuts, and the mitre gauge tracks ( for the sled runners) are out of parallel with the plane of the blade by 1.5mm over the width of the fully extended blade.
BUT there doesn't seem to be any way to adjust this.
I've had a good look but there's a round steel bar in the underside of the section of the top to which the saw is attached and it all seems to move as a unit. The steel bar is housed in a track in underside the top & the saw screws to the bar.
Can anyone tell me the adjustment process for the mitre guage track/blade alignmnet please?
Regards,
Rob.
ps I started to file away parts of the removable top panel which also has a mitre sled track, but thougth i'd ask for help before going any further.
I bought a GMC table saw new at auction to dedicate to one process.
However i need to build a cross cut sled to do up to two dozen short cuts, and the mitre gauge tracks ( for the sled runners) are out of parallel with the plane of the blade by 1.5mm over the width of the fully extended blade.
BUT there doesn't seem to be any way to adjust this.
I've had a good look but there's a round steel bar in the underside of the section of the top to which the saw is attached and it all seems to move as a unit. The steel bar is housed in a track in underside the top & the saw screws to the bar.
Can anyone tell me the adjustment process for the mitre guage track/blade alignmnet please?
Regards,
Rob.
ps I started to file away parts of the removable top panel which also has a mitre sled track, but thougth i'd ask for help before going any further.
0 commentaires:
Enregistrer un commentaire