I am after an 8" Bench Grinder with a 5/8" arbor (spindle) - NOT a 16mm (which is considered the same but is not). Ideally an older, quality machine, but I will consider others. Ideally 1 hp, but will consider 3/4 hp.
The quality of the wheels is not important as I have a CBN wheel to fit - hence the machine needs decent bearings.
Speed: I would prefer a half speed machine (1400 rpm) but will also consider full speed (2800).
Single phase is preferred, but a good 3-phase that may be adapted to variable speed is OK as well.
My contact details are below:
(the above is an image and will not act as a direct link)
Regards from Perth
Derek
The quality of the wheels is not important as I have a CBN wheel to fit - hence the machine needs decent bearings.
Speed: I would prefer a half speed machine (1400 rpm) but will also consider full speed (2800).
Single phase is preferred, but a good 3-phase that may be adapted to variable speed is OK as well.
My contact details are below:
(the above is an image and will not act as a direct link)
Regards from Perth
Derek
0 commentaires:
Enregistrer un commentaire