I appreciate the help and timely reply in another post earlier on about VFD's. I have wired up the VFD and attempted to start the Lathe motor. No start, no noise trying to start. All parameters correctly set, with the exception of "A"- output amps. The readout says 1.2 amps and We cannot seem to change it. I have the Hyanyang model for a 7.5 HP, single phase in 3 phase out. Motor is a 7.5 Hp, 220 3 phase, 23 amp, 1720 Rpm. At 1.2 amp output would the motor at least hum or slightly try to start?0527151448-00.jpg0527151448-00.jpg How do I proceed from here?
Inscription à :
Publier les commentaires (Atom)
0 commentaires:
Enregistrer un commentaire