Been having intermittent issues when trying to joint/plane the narrow edge of usually shorter length pieces (~1/2 meter and less) on my A3-31.
I always start out by planing one wide side followed by squaring up one of the narrow sides. The problem I'm having is that my piece is being planed at the start but as I get to the back end of the board it's no longer cutting, the result is a tapered bit of wood with the end that's last to leave the in-feed table being untouched. This never or rarely happens on longer boards or in fact when I'm not using the fence to joint the narrow edge. I'm thinking it has something to do with my technique. Any suggestions?
Thanks,
Gareth
I always start out by planing one wide side followed by squaring up one of the narrow sides. The problem I'm having is that my piece is being planed at the start but as I get to the back end of the board it's no longer cutting, the result is a tapered bit of wood with the end that's last to leave the in-feed table being untouched. This never or rarely happens on longer boards or in fact when I'm not using the fence to joint the narrow edge. I'm thinking it has something to do with my technique. Any suggestions?
Thanks,
Gareth
0 commentaires:
Enregistrer un commentaire