I have tried a number of times to get a Mat made to hold a small LCD screen in a photo frame.
I tried twice with plastic, then gave up and tried 3 times with MDF.
The issue I have is that the screen is perfectly square. Any small deviation in my cutting is obvious and looks terrible.
The plastic I used a cutting wheel on a Dremel trying twice. Both attempts looked terrible.
MDF I used
- Scroll saw. My line looked perfect, until I held it against the screen. I then saw it was all over the place.
- CNC ( I have calibration issues that I have no idea how long it will take to fix )
- Sharp knife and ruler
I thought about using a router with guides, but I don't think it will get into the corners properly.
Does anyone have any recommendations on how I can cut this square out perfectly?
Is there a material better than MDF or plastic I should use? I am trying to avoid using cardboard.
I tried twice with plastic, then gave up and tried 3 times with MDF.
The issue I have is that the screen is perfectly square. Any small deviation in my cutting is obvious and looks terrible.
The plastic I used a cutting wheel on a Dremel trying twice. Both attempts looked terrible.
MDF I used
- Scroll saw. My line looked perfect, until I held it against the screen. I then saw it was all over the place.
- CNC ( I have calibration issues that I have no idea how long it will take to fix )
- Sharp knife and ruler
I thought about using a router with guides, but I don't think it will get into the corners properly.
Does anyone have any recommendations on how I can cut this square out perfectly?
Is there a material better than MDF or plastic I should use? I am trying to avoid using cardboard.
0 commentaires:
Enregistrer un commentaire