Looking for help from you electrical type gurus.
Yesterday, for no apparent reason, and quite suddenly, my DC motor started to struggle on startup.
Where previously it would reach full revs in say 2 seconds, it now seems to take 5 seconds, drawing a very high current while doing so.
My shed is powered by a 20a dedicated circuit from the main board, and the only other draw on that circuit would be 6 double tube fluros.
I will pull the DC out today and make sure I don't have any obstructions. I am pretty sure there are none, because once at full revs, it draws the same current with a 6" port open as it always has.
Is it dying? Perhaps cap on the way out?
Yesterday, for no apparent reason, and quite suddenly, my DC motor started to struggle on startup.
Where previously it would reach full revs in say 2 seconds, it now seems to take 5 seconds, drawing a very high current while doing so.
My shed is powered by a 20a dedicated circuit from the main board, and the only other draw on that circuit would be 6 double tube fluros.
I will pull the DC out today and make sure I don't have any obstructions. I am pretty sure there are none, because once at full revs, it draws the same current with a 6" port open as it always has.
Is it dying? Perhaps cap on the way out?
0 commentaires:
Enregistrer un commentaire