Hi all,
Due to circumstances beyond my control, I must construct a desk/table to hold my Computer and it's ancillary bibs and bobs.
Here, then is the story of the table construction.
I decided to use Blackbutt and Tasmanian Blackwood (quite nicely figured), I had the Blackwood but needed Blackbutt. I needed 150 x 25mm and 100 x 38mm Blackbutt, which I bought for the princely sum of $15/lm and $20.00/lm respectively.
I am starting with the top, for no particular reason other than this will limit the size of the top.
Fig 1 shows the Blackbutt after dressing.
Fig 2 shows the frame for the top. You can see some nice figure in the Blackbutt.
Fig 3 shows the Blackwood (also nicely figured) sitting in the frame.
Next post will show the centre panels of Blackwood mounted in the frame and then glue up.
Regards,
Rob
Due to circumstances beyond my control, I must construct a desk/table to hold my Computer and it's ancillary bibs and bobs.
Here, then is the story of the table construction.
I decided to use Blackbutt and Tasmanian Blackwood (quite nicely figured), I had the Blackwood but needed Blackbutt. I needed 150 x 25mm and 100 x 38mm Blackbutt, which I bought for the princely sum of $15/lm and $20.00/lm respectively.
I am starting with the top, for no particular reason other than this will limit the size of the top.
Fig 1 shows the Blackbutt after dressing.
Fig 2 shows the frame for the top. You can see some nice figure in the Blackbutt.
Fig 3 shows the Blackwood (also nicely figured) sitting in the frame.
Next post will show the centre panels of Blackwood mounted in the frame and then glue up.
Regards,
Rob
0 commentaires:
Enregistrer un commentaire