Hello all.
I have a Triton router and recently used a 2" flush trim router bit (1/2" shank) for the first time.
I was trimming 17mm plywood with it. The bit kept on coming loose after routing about 400mm. I reset it and tightened it again and it did the same. it did this about 4 times, at which stage I decided it was not a good idea to keep on doing this. The bit is a Diablo bit sold by Bunnings. I did tighten it as much as I could and have never experienced this before but have never used such a long bit before.
Anyone have any ideas what could be causing this?
Thanks
I have a Triton router and recently used a 2" flush trim router bit (1/2" shank) for the first time.
I was trimming 17mm plywood with it. The bit kept on coming loose after routing about 400mm. I reset it and tightened it again and it did the same. it did this about 4 times, at which stage I decided it was not a good idea to keep on doing this. The bit is a Diablo bit sold by Bunnings. I did tighten it as much as I could and have never experienced this before but have never used such a long bit before.
Anyone have any ideas what could be causing this?
Thanks
0 commentaires:
Enregistrer un commentaire