gday you blokes - had a piece break off the table saw this morning it is one of four lugs that blade insert bears on - these are a part of the top casting which is aluminium now its a little rattly bearing on only 3 - set screws adjust the height to keep it level and flush with the top wondering if there is a decent product that will hold the broken bit in place perhaps the one that i have seen a video on that can hold engine bits together? - it is a two part operation where a filler is added then a catalyst sets off - although in this situation it might be a tricky situation to hold the sandy stuff in placed till the catalyst goes on any and all suggestions most welcome
Inscription à :
Publier les commentaires (Atom)
0 commentaires:
Enregistrer un commentaire