My C2 P.O.S lathe has a problem, in that it turns a taper of 20 mm at the tailstock end and 20.05 at the chuck end over a 27 mm length. Anyone else come across this on their unit?
Unfortunately it sits on an inverted V, so that it can't be straightened up easily, unless shims are installed underneath the headstock. With the .05 difference, would it need to be pushed away from the operator or towards, I can't quite work it out.:?
I realise the tailstock will also need modifying, to bring it back on centre.
Thanks
Kryn
Unfortunately it sits on an inverted V, so that it can't be straightened up easily, unless shims are installed underneath the headstock. With the .05 difference, would it need to be pushed away from the operator or towards, I can't quite work it out.:?
I realise the tailstock will also need modifying, to bring it back on centre.
Thanks
Kryn
0 commentaires:
Enregistrer un commentaire