Looking at the carbide numbering system , the older holders and inserts seem to be in imperial measurment . I have a chart and the dimensions given are in inches .
The present day holders and inserts are in metric as far as I can tell .
So these two systems will not change over ? A 16mm insert will only fit a 16mm holder ?
Mike
Read the full thread at metalworkforums.com...
The present day holders and inserts are in metric as far as I can tell .
So these two systems will not change over ? A 16mm insert will only fit a 16mm holder ?
Mike
Read the full thread at metalworkforums.com...
0 commentaires:
Enregistrer un commentaire