I want to make a 2400 long circular saw guide for ripping some 12mm thick pine ply.
I have some 4mm ply to use as the base of the guide, and I was hoping to use an offcut from my 12mm stock for the actual guide that the saw base presses against.
My question is how wide should the 12mm ply strip be without losing it's straightness before fixing it to the 4mm ply base sheet (I'll be ripping it off one stock edge of a 2400 x 1200 sheet)?:?
According to my cutting list, I can rip around 90mm maximum off one of my 12mm sheets to use for my 2400 guide.
I have some 4mm ply to use as the base of the guide, and I was hoping to use an offcut from my 12mm stock for the actual guide that the saw base presses against.
My question is how wide should the 12mm ply strip be without losing it's straightness before fixing it to the 4mm ply base sheet (I'll be ripping it off one stock edge of a 2400 x 1200 sheet)?:?
According to my cutting list, I can rip around 90mm maximum off one of my 12mm sheets to use for my 2400 guide.
0 commentaires:
Enregistrer un commentaire