Hoping you might be able to enlighten me with a small issue,
I have two 2.4 long boards on average about 300mm width, with one side a natural edge, I want to join them to make a top, I have been able to dress the top to the required thickness and have a large jointer, when I tried to joint the edge I ended up with slight variations due to the boards width/height/weight moving slightly, even with aid I imagine it would still wobble and cause a variation along the joint, I have done a dry run and there is a slight gap.
There must be a way to make the edge perfectly straight along the edge but at this point my brain is not looking elsewhere, hoping you can point me in the right direction.
Regards
GRaham
I have two 2.4 long boards on average about 300mm width, with one side a natural edge, I want to join them to make a top, I have been able to dress the top to the required thickness and have a large jointer, when I tried to joint the edge I ended up with slight variations due to the boards width/height/weight moving slightly, even with aid I imagine it would still wobble and cause a variation along the joint, I have done a dry run and there is a slight gap.
There must be a way to make the edge perfectly straight along the edge but at this point my brain is not looking elsewhere, hoping you can point me in the right direction.
Regards
GRaham
0 commentaires:
Enregistrer un commentaire