Apologies if this has been discussed before.......
I've just had a couple of pattern bits sharpened and, checking with a vernier, there is up to 0.4mm difference between the cutter and bearing diameter.
Not much in a general template, but significant in a box joint.
Do sharpening companies generally skim the bearing to match the cutter?
If not, what is the accepted tolerance?
I've just had a couple of pattern bits sharpened and, checking with a vernier, there is up to 0.4mm difference between the cutter and bearing diameter.
Not much in a general template, but significant in a box joint.
Do sharpening companies generally skim the bearing to match the cutter?
If not, what is the accepted tolerance?
0 commentaires:
Enregistrer un commentaire