Was wondering if anyone out there might happen to have a bolt kicking around that has a thread diameter of 1 3/4 inch with 6 threads per inch.
Have been considering getting a vicmarc chuck to suit my larger lathe however they don't offer an insert with this size thread.
For them to make up an insert they need a male thread of the right size, I have female threads of the right size on my faceplates but apparently a male thread is better so they can make sure sure the inserts fit properly.
Tried a nut and bolt specialist here in Hobart and they did have one high tensile bolt with the right sized thread but the cost was lofty.
Doesn't really matter if the bolt/thread is hollow, like on a pipe etc, or what sort of metal it's made from.
Have been considering getting a vicmarc chuck to suit my larger lathe however they don't offer an insert with this size thread.
For them to make up an insert they need a male thread of the right size, I have female threads of the right size on my faceplates but apparently a male thread is better so they can make sure sure the inserts fit properly.
Tried a nut and bolt specialist here in Hobart and they did have one high tensile bolt with the right sized thread but the cost was lofty.
Doesn't really matter if the bolt/thread is hollow, like on a pipe etc, or what sort of metal it's made from.
0 commentaires:
Enregistrer un commentaire