Folks,
Can somebody please enlighten me as to how to create accurate rounded ends on a length of timber as per the attached drawing.
I would like it to be as accurate a curve as possible, but short of roughing it out, and then sanding to a line, I can't see another way of achieving this, and it won't be as accurate as I would like.
I am talking about relatively small stock here, around the 20mm square and want the diameter of the curve to be equal to the width of the stock
Thanks
Ian
rounded end.jpg
Can somebody please enlighten me as to how to create accurate rounded ends on a length of timber as per the attached drawing.
I would like it to be as accurate a curve as possible, but short of roughing it out, and then sanding to a line, I can't see another way of achieving this, and it won't be as accurate as I would like.
I am talking about relatively small stock here, around the 20mm square and want the diameter of the curve to be equal to the width of the stock
Thanks
Ian
rounded end.jpg
0 commentaires:
Enregistrer un commentaire