As the title implies, I need to make a couple of low voltage connections which will be under water (up to 1.5m below the surface of our water tank). I need to fit a couple of reed float switches inside my tank and can;t do them through the wall. The two wires from each sealed switch are only about 200mm long. So I need to solder cables to them and seal the joints.
What options are available? Shrink sleeves with glue inside them are available, but the staff at the local shop couldn;t guarantee that they would be water pressure proof. I wondered about filling shrink sleeves with silicone before shrinking them.... or fitting glue-type shrink sleeves and then encase them in longer spagetti sleeves filled with epoxy, for example.
What's available for the purpose, please?
What options are available? Shrink sleeves with glue inside them are available, but the staff at the local shop couldn;t guarantee that they would be water pressure proof. I wondered about filling shrink sleeves with silicone before shrinking them.... or fitting glue-type shrink sleeves and then encase them in longer spagetti sleeves filled with epoxy, for example.
What's available for the purpose, please?
0 commentaires:
Enregistrer un commentaire