Hello, I have decided to give a lock mitre router bit a go on my router table to make some small boxes for my workshop. The boxes are of radiata pine, with sides 50-75mm wide and 300 long.
One pass requires the workpiece to be vertical, with the 50-75mm wide end of the board sitting on the table. My problem is pushing this narrow board along the fence while keeping it vertical at all times, and keeping the narrow end in complete contact with the table and the flat face of the board in total contact with the fence as the bit chews through the narrow end. Hope that makes sense.
Can anyone please suggest a jig that would allow me to do this, so that I can eliminate a major cause of error?
One pass requires the workpiece to be vertical, with the 50-75mm wide end of the board sitting on the table. My problem is pushing this narrow board along the fence while keeping it vertical at all times, and keeping the narrow end in complete contact with the table and the flat face of the board in total contact with the fence as the bit chews through the narrow end. Hope that makes sense.
Can anyone please suggest a jig that would allow me to do this, so that I can eliminate a major cause of error?
0 commentaires:
Enregistrer un commentaire