One of the chain and bars I got with My Stenner BL mortiser was one of the small gauge chains. can't remember the numbers for the 3 chain pitch sizes. I have never been able to run it though as it was missing the sprocket. had some one in the US quote me $150 for an old stock sprocket and thought it was to rich for my bottom feeder blood.
There was/is some tooling on the block up in the UK most of it old Reynolds Wadkin/ Robinson tooling, and i grabed this German necklace. I did the Buy it now as you just don't see these very often AND BEFORE I COULD THINK ABOUT. In fact i have never seen them come up . so for 75 GBP for the set i had to adjust my bottom feeder ways and click sold.
Any one know if that's a grease fitting or for an auto oiler?
bar looks real good to me?
any one seen or have any of the specal Wadkin doubles or triangle kits?
Looking for advice on handling this smaller chain tooling from users.
jack
English machines
There was/is some tooling on the block up in the UK most of it old Reynolds Wadkin/ Robinson tooling, and i grabed this German necklace. I did the Buy it now as you just don't see these very often AND BEFORE I COULD THINK ABOUT. In fact i have never seen them come up . so for 75 GBP for the set i had to adjust my bottom feeder ways and click sold.
Any one know if that's a grease fitting or for an auto oiler?
bar looks real good to me?
any one seen or have any of the specal Wadkin doubles or triangle kits?
Looking for advice on handling this smaller chain tooling from users.
jack
English machines
0 commentaires:
Enregistrer un commentaire