Anyone had any experience machining it!
It's a fairly simple job. I need to make water cooled plates.
The two plates are 160mm by 6mm by 800. I was planning on machining a 2mm ( ball nose) matching track, putting in a gasket and bolting them together. Then plumb in the inlet/outlet barbs.
I'm guessing sharp hss with WD40 in the Mill is the go or is it just too gummy?
It is classes as 'fair' machining but that really does not say a lot.
It's a fairly simple job. I need to make water cooled plates.
The two plates are 160mm by 6mm by 800. I was planning on machining a 2mm ( ball nose) matching track, putting in a gasket and bolting them together. Then plumb in the inlet/outlet barbs.
I'm guessing sharp hss with WD40 in the Mill is the go or is it just too gummy?
It is classes as 'fair' machining but that really does not say a lot.
0 commentaires:
Enregistrer un commentaire