Greetings. so I have a little ryobi disc/belt sander I am looking on sorting out the extraction for. My extractor is a 2hp holytek jobby so it has the motor already mounted up high blowing straight into the bags with a 125 to 2x100 on the top and the hose runs from that will be around 2m tops, while I would love to take it out to 150mm from the impeller I just haven't been able to find even vaguely sensibly priced 150mm fittings here in nz. I always use a respirator when doing any work and leave it on till I have vented the garage (main door is other end from extractor venting) so I am fairly comfortable with that part of the setup. I know I wont be able to catch all the fines from this tool
My current thinking was to build essentially a box around the disc table some distance back (so air can get around the table and down into the hose) and have the hose mounted at the end near where the existing factory "port" is. I dont use the table on an angle so I'm fairly happy with restricting that if needed. I would have one 100mm line going into the end (marked in red) and then place the other 100mm I have above /beside the part depending on what it is to catch the excess. The factory plate covering the lower half of the disc would be turfed for allow the air a good grab at it.
Picture of my rough idea attached.
disc sander options.jpg
The whole thing will be mounted on a board as I swap between tools and don't have acres of work bench
My thinking was if the back is also boxed up then I could remove the factory shroud from the end and the new box would take care of that end of the belt then I could also have a free hose to poke around the top when using the belt.
Any thoughts or anything I have missed?
My current thinking was to build essentially a box around the disc table some distance back (so air can get around the table and down into the hose) and have the hose mounted at the end near where the existing factory "port" is. I dont use the table on an angle so I'm fairly happy with restricting that if needed. I would have one 100mm line going into the end (marked in red) and then place the other 100mm I have above /beside the part depending on what it is to catch the excess. The factory plate covering the lower half of the disc would be turfed for allow the air a good grab at it.
Picture of my rough idea attached.
disc sander options.jpg
The whole thing will be mounted on a board as I swap between tools and don't have acres of work bench
My thinking was if the back is also boxed up then I could remove the factory shroud from the end and the new box would take care of that end of the belt then I could also have a free hose to poke around the top when using the belt.
Any thoughts or anything I have missed?
0 commentaires:
Enregistrer un commentaire