I picked up a couple of pieces of eucalypt (unknown sp) and would appreciate your thoughts on how best to mill these crotch pieces...they're pretty small but I'm hoping to get some interesting figure for small panels (like box lids) and veneers. They're only small with the largest being about 600mm)
Should I cut through the 3x piths centrally, or should I cut either side of the 3 piths (a quarter saw slab, with boxed heart).
The split on the first piece is only into the bark layer.
IMG_1865.jpg
IMG_1866.jpg
IMG_1867.jpg
Thanks,
John
Should I cut through the 3x piths centrally, or should I cut either side of the 3 piths (a quarter saw slab, with boxed heart).
The split on the first piece is only into the bark layer.
IMG_1865.jpg
IMG_1866.jpg
IMG_1867.jpg
Thanks,
John
0 commentaires:
Enregistrer un commentaire