Hi All,
I have a Jet 10 Inch ProShop Table Saw and need some advice re the riving knife clamp. I overtightened the clamp and stripped the cam. I have removed the tightening knob and want to remove the riving knive so that I can fit my dado blade. Unfortunately I can't recall which direction the knob would have needed to be turned to loosen the clamp. If I fit a vice-grip vertically on the clamp bolt, should I pull it toward or away from myself, assuming I am standing where one would normally stand when operating the saw?
Stupid mistake
overtightening in the first place!!
thanks for your help
I have a Jet 10 Inch ProShop Table Saw and need some advice re the riving knife clamp. I overtightened the clamp and stripped the cam. I have removed the tightening knob and want to remove the riving knive so that I can fit my dado blade. Unfortunately I can't recall which direction the knob would have needed to be turned to loosen the clamp. If I fit a vice-grip vertically on the clamp bolt, should I pull it toward or away from myself, assuming I am standing where one would normally stand when operating the saw?
Stupid mistake
thanks for your help
0 commentaires:
Enregistrer un commentaire