Hi,
I have acquired a back gear that I believe may be from a Sheraton 4.5" lathe.
It is not a Hercus (wrong tooth count and oil hole in wrong place).
I have no use for it, but before offering it to a good home, I'd be grateful if someone is able to confirm it.
Please see the photos.
Large gear: 4" OD, 62 teeth, 16 DP, face width 5/8"
Small gear: 1.624 " OD, 24 teeth, 16 DP, face width 5/8"
Gear spacing: Inside face dimension 3.774"
Bore: 0.749", Overall length 6.029"
Oil hole thread: loose fitting 0.25" x 20, located approx centrally between the two gears
Plain shaft OD: 1.314"
( Not relevant to the question in this post: One tooth on pinion has chip as shown (arrowed).)
I'd be grateful if anyone is able to confirm which machine it belongs to.
Thanks.
I have acquired a back gear that I believe may be from a Sheraton 4.5" lathe.
It is not a Hercus (wrong tooth count and oil hole in wrong place).
I have no use for it, but before offering it to a good home, I'd be grateful if someone is able to confirm it.
Please see the photos.
Large gear: 4" OD, 62 teeth, 16 DP, face width 5/8"
Small gear: 1.624 " OD, 24 teeth, 16 DP, face width 5/8"
Gear spacing: Inside face dimension 3.774"
Bore: 0.749", Overall length 6.029"
Oil hole thread: loose fitting 0.25" x 20, located approx centrally between the two gears
Plain shaft OD: 1.314"
( Not relevant to the question in this post: One tooth on pinion has chip as shown (arrowed).)
I'd be grateful if anyone is able to confirm which machine it belongs to.
Thanks.
0 commentaires:
Enregistrer un commentaire