Can anyone assist with a problem Craftsman Spindle.
I have attempted to remove mine from the lathe head but it steadfastly refuses to comply. It will move about 10mm forward and that is all. I've tried gentle persuasion with hammer via a block of wood as well as a hydraulic press, to no avail. I'm about to construct a puller to try to draw the shaft through the bearings/bull gear etc.
Does anyone have advice for dealing with an non-conforming Craftsman spindle (and its frustrated owner)?
Thanks in advance,
Arthur
I have attempted to remove mine from the lathe head but it steadfastly refuses to comply. It will move about 10mm forward and that is all. I've tried gentle persuasion with hammer via a block of wood as well as a hydraulic press, to no avail. I'm about to construct a puller to try to draw the shaft through the bearings/bull gear etc.
Does anyone have advice for dealing with an non-conforming Craftsman spindle (and its frustrated owner)?
Thanks in advance,
Arthur
0 commentaires:
Enregistrer un commentaire