I want to make a wooden drill press table and I had a Thick MDF off cut from a job a forum member had worked donated to me for this purpose.
I intend to fit a few rows of T track and maybe some nice red gum edges.
The plan is to have the table surround the drill pillar like a yolk. So I'm wondering what would the best way to cut a nice clean round hole ¾ off the into the board??
I don't have any hole saws and I think the column too large a dia. No bandsaw or jigsaw to use. Would a jigsaw cut 40mm mdf?? What about those old fashioned adjustable bladed hole cutters or are they for sheet goods?
Also what is the usual finish for mdf??
I intend to fit a few rows of T track and maybe some nice red gum edges.
The plan is to have the table surround the drill pillar like a yolk. So I'm wondering what would the best way to cut a nice clean round hole ¾ off the into the board??
I don't have any hole saws and I think the column too large a dia. No bandsaw or jigsaw to use. Would a jigsaw cut 40mm mdf?? What about those old fashioned adjustable bladed hole cutters or are they for sheet goods?
Also what is the usual finish for mdf??
0 commentaires:
Enregistrer un commentaire