I had a wee accident at work yesterday (and funnily enough, again today) ripping some curvy sticks to correct thickness on the table/panel saw. Because there were no flat surfaces to speak of, the push stick would sometimes lift and tilt the workpiece.
Whilst 22 of the sticks went through without trouble, 2 of them decided they wanted to enter low earth orbit and shot up and backwards out of the saw.
Can you find where the first one ended up? :U:B
kickback3.jpg
The workpiece where it stopped.
kickback1.jpg
Long shot from the panel saw...it's back there somewhere...
kickback2.jpg
Last clue...the workpiece has been removed...does that help? :q
If no-one spots it soon, I'll highlight where it landed later in the week.
Whilst 22 of the sticks went through without trouble, 2 of them decided they wanted to enter low earth orbit and shot up and backwards out of the saw.
Can you find where the first one ended up? :U:B
kickback3.jpg
The workpiece where it stopped.
kickback1.jpg
Long shot from the panel saw...it's back there somewhere...
kickback2.jpg
Last clue...the workpiece has been removed...does that help? :q
If no-one spots it soon, I'll highlight where it landed later in the week.
0 commentaires:
Enregistrer un commentaire