Here is the ASEA 2 pole 3 phase Star wound motor from the Hercus No.1 tool and cutter grinder. I need to have the thing wired in Delta configuration. It is certainly a marked contrast to Simon's motor as far as clarity goes. http://ift.tt/1iae93H
The varnish on mine looks like spit and is copious in its application. The red wire disappears under the copper and the brown wire, while visible ends up buried in the copper also. The bandage like tape lashing looks a bit trickier to unravel and replace than the twine on Simon's. I could have a dig around but I don't want to stuff things up.
I have never dealt with any rewinders here in Perth. Any suggestions about digging or rewinders? The housing minus the rotor is light hence postable. The tool capital or anywhere else is not too far away.
Bob.
008 (Large).JPG099 (Large).JPG105 (Large).JPG109 (Large).JPG110 (Large).jpg111 (Large).JPG
Simon's motor.
2012-10-09_13-24-54_650.jpg
ps. Alan ( C-47) was the place you went to out near FJ Sweetman's ???
The varnish on mine looks like spit and is copious in its application. The red wire disappears under the copper and the brown wire, while visible ends up buried in the copper also. The bandage like tape lashing looks a bit trickier to unravel and replace than the twine on Simon's. I could have a dig around but I don't want to stuff things up.
I have never dealt with any rewinders here in Perth. Any suggestions about digging or rewinders? The housing minus the rotor is light hence postable. The tool capital or anywhere else is not too far away.
Bob.
008 (Large).JPG099 (Large).JPG105 (Large).JPG109 (Large).JPG110 (Large).jpg111 (Large).JPG
Simon's motor.
2012-10-09_13-24-54_650.jpg
ps. Alan ( C-47) was the place you went to out near FJ Sweetman's ???
0 commentaires:
Enregistrer un commentaire