I was using my machine today and went crazy. I had already cut a couple of pieces with no problems
It made its first cut and when it went to its second cut it jumped over about 2mm
It got half way around and then started going backwards and forwards then got back on track again.
I stopped it and you can see in the screen dump below that the position on the screen doesn't match the code displayed
I re-generated the code a couple of times but that had no effect.
Any ideas on what to check would be appreciated
Warrick
crazy.jpg
It made its first cut and when it went to its second cut it jumped over about 2mm
It got half way around and then started going backwards and forwards then got back on track again.
I stopped it and you can see in the screen dump below that the position on the screen doesn't match the code displayed
I re-generated the code a couple of times but that had no effect.
Any ideas on what to check would be appreciated
Warrick
crazy.jpg
0 commentaires:
Enregistrer un commentaire