Hi. I'm a newbie in CNC. I am working up a model in Rhino of a stratocaster type guitar.
I've hit a wall when attempting to fillet the top edges. (The bottom went well).
the edge is broken by a cut out for the guitar neck and this is where the filleting or sweeping goes haywire,
Obviously it's the very sharp junctions ot the neck point causing the problem....how do I get rond this? Would a zero radius on the sharp bits help?
This is my first attempt.
Thanks,
Rob
forum question.pdf
I've hit a wall when attempting to fillet the top edges. (The bottom went well).
the edge is broken by a cut out for the guitar neck and this is where the filleting or sweeping goes haywire,
Obviously it's the very sharp junctions ot the neck point causing the problem....how do I get rond this? Would a zero radius on the sharp bits help?
This is my first attempt.
Thanks,
Rob
forum question.pdf
filleting issue in Rhino 3D
0 commentaires:
Enregistrer un commentaire