I recently picked up a TWM aka "Millers Falls" multi function wet grinder similar to these:
$_20.jpg
ad4.jpg
I know that a lot of people aren't fans of these units, but the price was pretty darned good, and the test was impressive. I couldn't see the 5" wheel moving when it was turned on, but after a quick poke with a bit of steel, I determined it was indeed running, just very smoothly.
The larger, slower wet wheel above is a different story. It has a very slight "wobble", but am not sure if this could be taken out of it by dressing the stone somehow. Anyone got a suggestion?
As an aside, I note that these are a Chinese copy of the apparently unpopular 73-710 Delta Sharpening Centre, complete down to screw holes for accessories that they don't come with :) Mine didn't come with a manual, but the Delta unit manual is spot on.
I'd be grateful for any advice that will allow me to get this up and running as well as possible.
Thanks,
Craig
$_20.jpg
ad4.jpg
I know that a lot of people aren't fans of these units, but the price was pretty darned good, and the test was impressive. I couldn't see the 5" wheel moving when it was turned on, but after a quick poke with a bit of steel, I determined it was indeed running, just very smoothly.
The larger, slower wet wheel above is a different story. It has a very slight "wobble", but am not sure if this could be taken out of it by dressing the stone somehow. Anyone got a suggestion?
As an aside, I note that these are a Chinese copy of the apparently unpopular 73-710 Delta Sharpening Centre, complete down to screw holes for accessories that they don't come with :) Mine didn't come with a manual, but the Delta unit manual is spot on.
I'd be grateful for any advice that will allow me to get this up and running as well as possible.
Thanks,
Craig
0 commentaires:
Enregistrer un commentaire