I realise this has been dealt with on numerous occasions but I thought I'd put it up in new thread. I have been asked by new owners repeatedly for the standard gear setup for all the B and C model lathes. This is the basic set for the lowest feedrate hence the best finish. It does not include the ones required for higher feedrates or thread cutting. All models excluding the A and AM have this as the basic turning set.
This setup should enable the user to achieve a bright finish in general turning work, depending on spindle speed and tool tip geometry. The attached photo shows how this is setup.
Mal
This setup should enable the user to achieve a bright finish in general turning work, depending on spindle speed and tool tip geometry. The attached photo shows how this is setup.
Mal
0 commentaires:
Enregistrer un commentaire