just recently bought a second hand ( but appears unused) rotary table of unknown origin came with a chuck and dividing plates 23 25 28 31 39 43 and 19 27 30 33 41 47.
the confusing part for me is its 67: 1 turns for 360 degrees and each revolution of the handle is divided into 150 divisions
how do you work out say marking out a 4 hole back plate for a chuck back plate??
the unit is unsealed but covered in grease the lub points have those little ball type for oiling should i clean grease off and use oil
john
the confusing part for me is its 67: 1 turns for 360 degrees and each revolution of the handle is divided into 150 divisions
how do you work out say marking out a 4 hole back plate for a chuck back plate??
the unit is unsealed but covered in grease the lub points have those little ball type for oiling should i clean grease off and use oil
john
0 commentaires:
Enregistrer un commentaire