I need to fit a bush about 1" in from the end of a piece of tube, and ideally it will stay in place without needing to pinned from the outside of the tube.
This is a steering column for an old car - 35 Hudson if anyone is into Hudsons. The tube is 1.5" OD x 1.375" ID, the shaft that needs the bush is .75", bush walls are going to end up a nominal 5/16". The bush will be 1.25" long.
I'm thinking of using nylon and that .002 or .003 over on the OD of the nylon should give me a stay in place fit.
Any thoughts or other suggestions?
This is a steering column for an old car - 35 Hudson if anyone is into Hudsons. The tube is 1.5" OD x 1.375" ID, the shaft that needs the bush is .75", bush walls are going to end up a nominal 5/16". The bush will be 1.25" long.
I'm thinking of using nylon and that .002 or .003 over on the OD of the nylon should give me a stay in place fit.
Any thoughts or other suggestions?
0 commentaires:
Enregistrer un commentaire