Hi,
After several years of not having to cut a thread on a lathe, I've attempted to do so on my Hercus 260ATM.
Unfortunately my first attempts have been unsuccessful.
I finally got the gears right to cut the desired thread. Compound set at a bit over 29 degrees. OD at 16mm for a M16 x 2.0 pitch. I'm cutting using the reversing method.
The vee formed is not right, and I'm not sure about the OD.
Any ideas? Sorry about the quality of the photo's, straight off my phone.
Ben.
After several years of not having to cut a thread on a lathe, I've attempted to do so on my Hercus 260ATM.
Unfortunately my first attempts have been unsuccessful.
I finally got the gears right to cut the desired thread. Compound set at a bit over 29 degrees. OD at 16mm for a M16 x 2.0 pitch. I'm cutting using the reversing method.
The vee formed is not right, and I'm not sure about the OD.
Any ideas? Sorry about the quality of the photo's, straight off my phone.
Ben.
0 commentaires:
Enregistrer un commentaire