I picked up this unit around 3 or 4 years ago for $40 and it has been used in it's neglected state since. Probably one of the last made in Aust by GMF Betts, it is dated June 1988 and drills an accurate hole with no run out. On fitting a new belt last week I noticed the idler pulleys were sitting low and pulling them to realign, led to the decision to do a rebuild. It has always been missing one arm, someone has welded the MT into the spindle and the rack is missing it's top collar. The table angle adjust has also been welded, so these need sorting out. I am also thinking about fabricating up a belt tensioner like the waldowns have if I can make it fit.
If anyone else has one of these could they please post up pictures of the rack collar and the belt tensioner?
If anyone else has one of these could they please post up pictures of the rack collar and the belt tensioner?
0 commentaires:
Enregistrer un commentaire