I'm about to start a project of bending wood for the backs of chairs. The size of the back is to be 55 or 60 CM. The curve itself shouldn't be much deeper than 20 MM. The plan was to mill three pieces about 6.5 MM thick and steam bend those pieces.
After reading about the difficulties of Fletty's efforts in bending pallet wood, I'm rather wary. Perhaps I should start with 4 pieces of 4.75 MM thick?
Any advice or thoughts would be greatly appreciated.
Oh, the wood is American White Oak.
After reading about the difficulties of Fletty's efforts in bending pallet wood, I'm rather wary. Perhaps I should start with 4 pieces of 4.75 MM thick?
Any advice or thoughts would be greatly appreciated.
Oh, the wood is American White Oak.
0 commentaires:
Enregistrer un commentaire