TECO Single Phase Motor for Hercus No.O

Ken had asked me for some photos of the motor I once had powering my mill. I paid a bit over 200 dollars for the TECO. I subsequently located a star/delta wound ASEA motor of the same size and appearance as the original ASEA fitted by Hercus which I ran via a TECO FM50 VFD. The motor is about 300mm in length, roughly 85 mm longer than the original.

I'm posting the photos here because there's a good chance Ken would lose them if I sent them to him.:rolleyes:

BT

Attached Images

• DSC_4610 (Large).JPG (99.6 KB)
• DSC_4612 (Large).jpg (115.0 KB)
• DSC_4613 (Large).jpg (125.2 KB)
• DSC_4614 (Large).jpg (138.4 KB)
• DSC_4616 (Large).jpg (100.3 KB)