Today I was thinking about how to get my mill table square with the Y axis again after I finish fitting the DRO's. I decided that it would be best to buy a Precision Engineers Square.
All the ones I have found on the net have had double bevelled edges. As I want to run a DTI along the edge I don't think these are suitable. I have not been able to determine how much of a flat surface is left tho.
Any suggestions?
Dean
All the ones I have found on the net have had double bevelled edges. As I want to run a DTI along the edge I don't think these are suitable. I have not been able to determine how much of a flat surface is left tho.
Any suggestions?
Dean
0 commentaires:
Enregistrer un commentaire