Hello, I have made my first attempt at putting Qld Silver Ash stringing around the outside of a jarrah box. The strnging is 3mm wide and after fitting into a groove and gluing, it sits 1-2mm above the box surface.
Can anyone please recommend a good way of reducing this stringing flush with the box sides? I don't particularly want to sand it as the Silver Ash finish will become tainted by the red jarrah dust.
I am not sure about using a block plane, in case it ploughs into the jarrah box side - like, I am not going to keep the blade dead level all the time while planing the stringing. Or is there a technique that prevents that?
Can anyone please recommend a good way of reducing this stringing flush with the box sides? I don't particularly want to sand it as the Silver Ash finish will become tainted by the red jarrah dust.
I am not sure about using a block plane, in case it ploughs into the jarrah box side - like, I am not going to keep the blade dead level all the time while planing the stringing. Or is there a technique that prevents that?
0 commentaires:
Enregistrer un commentaire