Triton router mounting hole spacing

I'm finally getting work done on the router table I started ages ago.

The top has been made and it's getting time to think about drilling it and the router plate.



I'm creating an MDF template on the CNC router to suit my Woodhaven.com router plate.

I also want to cut out the phenolic route plate on the CNC so I can set up the centre hole for a zero clearance insert. It makes sense to do the drilling for the mounting holes for the TRC-001 router that's going to be attached.



My question is, does anyone have a template diagram for the base on the TRC-001 router? I'm after something with measurements so I can work out some parameters for the CNC router. I know I could measure the hole spacing but if there's an official drawing for this, at least I can blame the mistakes on someone else :)



Most of the forum search hits for mounting the Triton to a router plate say to use the black base plate as the template butI want to do all the drilling on the CNC router to ensure that the centre hole and the mounting holes are concentric.

I know router plates are available with the holes already drilled but I got the blank router plates some time ago before I'd decided on which router I was going to use so I'm stuck with them..