I've recently been turning some larger stuff and I've made my first few attempts at filling cracks with CA glue. Cracks have been a mil wide max. I've been successful, but not as successful as I would like. I have the medium viscosity and high viscosity Hot Stuff glues and the Hot Stuff accelerant.
I seem to have a lot of trouble sanding off the glue stains. I have even used 60 grit and, as we all know, that's just not fun for anyone...
I've ultimately gotten frustrated and just gone back to shear scraping. This works, but tends to go a bit too deep and open up some microgaps in the glue fill that were otherwise not there when I was previously attempting to sand. I then have to refill, reapply accellerant, wait, and then go again with the sanding/scraping, sometimes several times and, well...
aaa.jpg
Anyone got any pointers for me?
Thanks a lot,
Luke
I seem to have a lot of trouble sanding off the glue stains. I have even used 60 grit and, as we all know, that's just not fun for anyone...
I've ultimately gotten frustrated and just gone back to shear scraping. This works, but tends to go a bit too deep and open up some microgaps in the glue fill that were otherwise not there when I was previously attempting to sand. I then have to refill, reapply accellerant, wait, and then go again with the sanding/scraping, sometimes several times and, well...
aaa.jpg
Anyone got any pointers for me?
Thanks a lot,
Luke
0 commentaires:
Enregistrer un commentaire