I'm wondering if anyone else has dealt with this before.
When using my Carbatec 10" combination thicknesser/jointer as a thicknesser the cast iron feed in roller clogs. What seems to happen is that the shavings from the cutters are blown back around the roller which then rolls over them, compressing them into the grooves. This builds up in only a couple of metres of timber to the point where the roller won't feed the timber. I have a 2kw blower for shaving removal that is working fine and I'm a bit stumped. It happens only on the center of the roller, even when I'm using the full width of the thicknesser.
Anyone seen this before?
When using my Carbatec 10" combination thicknesser/jointer as a thicknesser the cast iron feed in roller clogs. What seems to happen is that the shavings from the cutters are blown back around the roller which then rolls over them, compressing them into the grooves. This builds up in only a couple of metres of timber to the point where the roller won't feed the timber. I have a 2kw blower for shaving removal that is working fine and I'm a bit stumped. It happens only on the center of the roller, even when I'm using the full width of the thicknesser.
Anyone seen this before?
0 commentaires:
Enregistrer un commentaire