Hi, Matt here...
I was looking at fabricating my own CS milling attachment so I can cut a few slabs of my own. I haven't seen any working in the flesh, all I can go off is drawings online that a few of the members have made themselves.
Anyone on the Sunshine Coast do any CSMilling that may need a hand for a day or two who could show me the ropes in return for some hard yakka before I get into the fabrication side too deep?
Also, I have an MS391 that I will be starting off on so that I get the hang of how to do the milling work. Anyone got any recommendations on the maximum size bar I can run? Or the most efficient size to run?
Thanks in advance guys...
Matt
I was looking at fabricating my own CS milling attachment so I can cut a few slabs of my own. I haven't seen any working in the flesh, all I can go off is drawings online that a few of the members have made themselves.
Anyone on the Sunshine Coast do any CSMilling that may need a hand for a day or two who could show me the ropes in return for some hard yakka before I get into the fabrication side too deep?
Also, I have an MS391 that I will be starting off on so that I get the hang of how to do the milling work. Anyone got any recommendations on the maximum size bar I can run? Or the most efficient size to run?
Thanks in advance guys...
Matt
0 commentaires:
Enregistrer un commentaire