hey guys thought this would be the best forum to ask this
i recently purchased a dirt motor bike and the chain came off on the old owner punching a small 5x3mm hole in the crankcase, the crankcase is cast aluminium
i have three options
JB weld it (looks dodgy to new buyers if i sell it)
weld it with aluminum brazing rod
or
weld it with my spool gun
pulling the engine apart to repair such a small hole will result in me rebuilding the engine and spending $700-$1000 so its just not economical
what would u do in this case?
crankcase hole 001.jpgcrankcase hole 002.jpg
i recently purchased a dirt motor bike and the chain came off on the old owner punching a small 5x3mm hole in the crankcase, the crankcase is cast aluminium
i have three options
JB weld it (looks dodgy to new buyers if i sell it)
weld it with aluminum brazing rod
or
weld it with my spool gun
pulling the engine apart to repair such a small hole will result in me rebuilding the engine and spending $700-$1000 so its just not economical
what would u do in this case?
crankcase hole 001.jpgcrankcase hole 002.jpg
0 commentaires:
Enregistrer un commentaire